Composites World / NetComposites

Connecting you to the composites industry

Advertisement

NetComposites Ltd has transferred the rights and ownership of this website to Gardner Business Media Inc.

On 1st January 2020, NetComposites' media assets including netcomposites.com, newsletters and conferences were transferred to Composites World (Gardner Business Media).

This site is no longer being updated. Please direct all enquiries to netcomposites@gardnerweb.com.

For further details see our joint press release.

Walk-In Batch Oven Cures Composites for Aerospace Industry

  • Tuesday, 5th July 2011
  • 0 comments
  • Reading time: about 2 minutes

More in Aerospace

Alvant Recognised at BEEA Awards

  • 21st October 2019

Greene Tweed Launches Fusion 665

  • 16th October 2019

Evonik Adds to the TROGAMID(r) Product Group

  • 15th October 2019

Wisconsin Oven has designed and manufactured a gas-fired walk-in batch oven to cure composite material for the aerospace industry.

The oven is divided into two independent chambers that are separated by a vertical lift door which can be opened to combine the chambers for curing long parts. The front section of the composite curing oven has a useable chamber length of 25’0”and the rear section has a useable chamber length of 20’0”. When the centre door is open the curing oven has an overall useable chamber length of 45’0”. The oven was designed with the capacity to heat a 3,500 pound load (per oven section) of composite material from 70° to 300° F within one hour when loaded into an ambient oven.

The composite curing oven has total chamber dimensions of 12’0” wide x 46’0” long x 8’0” high and a maximum operating temperature of 500º F. The composite curing oven is constructed with 6” thick tongue and groove panel assemblies and 20 gauge aluminised steel interiors and ductwork. Each individual chamber utilises a 1,500,000 BTU per hour industrial air heat burner including a motorised gas control valve, flame detector and flame relay with alarm horn. The front chamber recirculation system has a 37,000 CFM @ 30 HP blower and the rear chamber has a 30,000 CFM @ 25 HP blower. A combination airflow design was used to maximise heating rates and temperature uniformity.

The industrial batch oven is specifically designed with composite curing features for precise temperature and pressure control. The exhaust features motorised dampers on both the fresh air inlet and the exhaust outlet for enhanced heating and cooling capabilities. The vacuum system has a total of eighty (80) interior vacuum stubs and forty (40) vacuum ports located throughout the oven. The oven also has eighty (80) type “J” thermocouple jacks and a jack panel wired to the data acquisition system for control and recording. All of these composite curing features provide the customer with the ability to closely monitor part temperatures for a high quality cure. For more information on composite curing ovens visit our website at


For more information visit:


Share this article


Categories


More News


Comments (0)

Leave your comment