Composites World / NetComposites

Connecting you to the composites industry


NetComposites Ltd has transferred the rights and ownership of this website to Gardner Business Media Inc.

On 1st January 2020, NetComposites' media assets including, newsletters and conferences were transferred to Composites World (Gardner Business Media).

This site is no longer being updated. Please direct all enquiries to

For further details see our joint press release.

Delcam to Demonstrate Composite Machining at JEC

  • Friday, 19th February 2010
  • Reading time: about 3 minutes

NC-PartLocator is due to be demonstrated at JEC 2010. The software helps users to adjust toolpaths to the actual position of the part, rather than having to ensure that the component is in exactly the nominal location specified in the CAM system.

To ensure accurate trimming and profiling, NC-PartLocator first gathers the necessary data using a probe fitted onto the machine tool. A probing sequence is created within the software to collect a series of points from the component. This data is then used by best-fit routines within the software to determine the part’s exact position. Any mismatch between the nominal position used in the CAM system to generate the toolpaths and the actual position of the component on its fixture can be calculated. The software then feeds the results to the machine tool control as a datum shift or rotation to compensate for the differences in location and alignment. This adjustment can be made much more quickly and easily than placing, and holding, the part in exactly the specified position, especially with large, flexible components.

NC-PartLocator can also help to tackle localised problems that can result from variations in material thickness across the part, or from distortion within the part caused by differing cure rates or cooling rates in different areas.

For example, the software can ensure that fixing holes are drilled to the correct depth. The actual surface of the component can be mapped with NC-PartLocator and this surface used to calculate the drilling routine. This should provide more reliable results than using the nominal data from the CAD model of the part.

A second problem that can occur when drilling composites is that the part can distort as the reinforcement is cut. NC-PartLocator can overcome this issue by using a two-stage drilling operation. The first sequence is done using an under-size drill, typically half of the size required for the final hole. The surface of the part is then scanned and the results used in a second drilling routine with the correct size of tool. According to Delcam, any distortion of the part will be picked up by the scan and the centres for the second series of holes can be adjusted accordingly.

NC-PartLocator could also help to save time by eliminating the process of machining parts that are already scrap. The process can discover, during the set-up phase, that the component is so distorted that no realignment will give a satisfactory part.

For more information visit:

Share this article

More News

Comments (0)

Leave your comment