NetComposites

Connecting you to the composites industry

Advertisement

AOC and ECS Environmental Solutions Manufacture Wastewater Tunnel

  • Tuesday, 7th May 2013
  • 0 comments
  • Reading time: about 3 minutes

AOC and ECS Environmental Solutions worked together to create an integral part of the city of Austin’s complex wastewater infrastructure project.

The companies say the new 3.9 mile wastewater tunnel increases capacity for the downtown district and facilitates residential and business growth in the area. An important part of the project is an odour control system.

ECS claim it provided the odour control equipment and relied on AOC’s Vipel resin for more than 1,000 feet of fibreglass ductwork and additional accessories. The ductwork ranges in size from 12 inches to 72 inches in diameter. Approximately half of the ductwork is buried below ground and had to be able to withstand thousands of pounds of high-density traffic driving over the site. Additional elements of the project include field joint kits, flexible connectors, control and back-draft dampers, bolt gaskets and two fibreglass exhaust fans rated at 40,000 cubic feet per minute (CFM).

ECS say it manufactured all of the fibreglass ductwork using a state-of-the-art computerised filament winder. The fibre was impregnated with AOC’s Vipel K022 corrosion-resistant vinyl ester resin, which is ideally suited for filament winding. “The K022 resin was the best choice for this project,” says Jeff Jones, President of ECS. “Some of the gases in the air stream are corrosive – hydrogen sulphide and ammonia. There’s also sulphuric acid. Pipes built with this resin are very resistant to what goes in them: They will not easily corrode.”

The company say that to help ease installation, it prefabricated and sub-assembled the duct system at its facility, then shipped it to Austin about an hour away. A field crew of five from ECS travelled to the construction site and handled all the field layup.

“We work in a controlled environment in the shop, but in the field you are open to the elements,” says Jones. “Some of the days we were in Austin were cold and others were really hot. We had to adjust promotion levels and add inhibitors to work with the resin long enough to do a quality job under tough conditions.” AOC’s Scott Lane, Product Leader, offered technical assistance that helped ECS re-formulate the resin. Eric Stuck, AOC sales representative, also assisted ECS in meeting the demands of this material-intensive project. “With the long runs and thick pipes, we went through material much faster than normal, and AOC was very good at meeting this fluctuation in demand,” says Jones. “If we ran out of resin on this job, it would have put the project to a halt. AOC got materials here when we needed them. They were fantastic to work with!”

Photo provided by Kelley and Associates Advertising.


For more information visit:


Share this article


Categories


More News


Comments (0)

Sign in or create an account to join in the discussion.

Leave your comment

Advertisement

Upcoming Events

Advertisement

Advertisement

Advertisement

Follow us
Subscribe to our email newsletter

Subscribe to receive our weekly round-up of all the industry's latest news, jobs, events and more!

We'll always keep your personal details secure and will never share them with third parties for marketing purposes. You can unsubscribe at any time. For further details on how we may use your data, please visit our Privacy Policy.