NetComposites
Airtech

Osirys Project to Run Workshop as Parallel Session at CompIC 2017

10 January 2017

Osirys Project to Run Workshop as Parallel Session at CompIC 2017

On 31st January 2017, the Osirys Project consortium will be holding a project workshop to deliver its results to the construction industry as a parallel session at CompIC 2017 (Composites in Construction Conference), Amsterdam.

Indoor air quality and emissions from building materials has been, over recent decades, a major challenge for scientists, industry and consumers as traditional construction materials contribute to contaminants.

The Osirys project has been developing technology to improve indoor environmental quality and energy efficiency by evolving forest-based biocomposites and products for façades and interior partitions. These new technologies can then be applied in retrofitting and new building construction.

The workshop will look at drivers for the use of bicomposites in construction as well as factors affecting design and manufacturing. The workshop will end with an open discussion. The session is free-to-attend, but places are limited. Join in the discussion by registering at osirysproject.eu/registration.

Attendees are also recommended to attend CompIC 2017, which will take place on 31st January and 1st February at the same location. For more information visit http://compositesin.construction.

 


Photo provided by Osirys Project




Share this story


Related / You might like...

GreenLight Project to Present Its Results at the Ecocomp 2019 Conference

Environmental awareness has stimulated an increased interest in sustainable materials and issues such as recyclability and environmental responsibility are becoming ever more important.

JEC World Reinforces Its Leadership as the Foremost Event of the Composite Materials Industry

JEC World 2019 closed successfully on Thursday, 14 March, after three intense days of innovation, networking and knowledge sharing.

CRP USA Speaker at AMUG 2019 with Successful Use of AM in Aerospace Mission

CRP USA will be attending Additive Manufacturing Users Group (AMUG) as speaker. The 31st edition of AMUG will be held from 31 March to 4 April 2019, at the Hilton Chicago, in Chicago, Illinois, US.