Looking for our consultancy, conferencing, training or innovation services? Visit netcompositesenterprise.com

NetComposites Now
Attwater

Composite Advantage Taps Custom FRP Fabricator FiberSystems For Composite Pile Jackets

20 December 2016

Composite Advantage Taps Custom FRP Fabricator FiberSystems For Composite Pile Jackets

When FRP manufacturer Composite Advantage was asked to supply composite pile jackets for a waterfront application, it turned to nearby neighbour FiberSystems.

“We specialise in very large FRP composite parts up to 100 ft. for bridge and waterfront infrastructures,” says Composite Advantage President, Scott Reeve. “This was an application where the best approach was to source a pipe expert like FiberSystems.”

Composite Advantage explains that a New Zealand waterfront structure’s circular piers were eroding due to salt water, air and sun exposure. Concrete stay-in-place forms were used to repair the piers but corrosive conditions dictated the need for pile jackets for each of the piers. “FiberSystems had the mandrel sizes and the right manufacturing process to tackle the job,” says Reeve. “If a customer request falls outside our core competency, we’re able to use our network to meet that need.”

According to Composite Advantage, twenty-four ounce fabric knitted from carbon and glass fibres, 50 in. wide by 17 ft. long, was hand laid up in two sections around mandrels 18”, 20”, and 24”in diameter. Once the sleeves were custom fabricated, they were removed and split lengthwise. The outer edge of one side of the cut and the inner edge of the opposing cut were pre-sanded to facilitate easy bonding. Once installed, a special mortar is used to fill the space between the FRP jacket and the concrete pillar, creating a corrosion resistant armor against the elements.

“It was a labour intensive process,” says Tim Morton, Vice President of Operations for FiberSystems. “We had to adapt the process to meet the criteria needed to make the pile jackets. But we’re known as a fabricator’s fabricator. We are able to take a customer’s requirements and determine the best approach whether it means customising processes or in some cases, creating new methods to complete a job.”

FiberSystems says it used unpigmented vinylester resin to produce a total of 17 18”, inside diameter, five 20” inside diameter, and seven 24” inside diameter pile jackets. The FRP sleeves were shipped to New Zealand in October.


Photo provided by FiberSystems





comments powered by Disqus

Related / You might like...

A Joint Success in Bridge Repair Using Composites

The University of Southern Queensland’s (USQ) Centre for Future Materials (CFM) has partnered with Joinlox to investigate a prefabricated composite repair system with an easy-fit and self-locking mechanical joint called PileJax.

Federal-Mogul Earns DNV Certification for Composite Bearing Material

Federal-Mogul Powertrain's self-lubricating deva.tex 552 Marine composite bearing material has been certified by ship and offshore classification society DNV GL.

SAERTEX Collaborates on World´s Largest Carbon Spar Cap

SAERTEX reports that it has contributed to the prototype production of a wind turbine blade with probably the longest and thickest carbon fibre spar cap made in vacuum infusion technology so far.