06 October 2015
06 October 2015
Airbus Helicopters is replacing aluminum in a fitting in the aircraft door of the Airbus A350-900 with a high-modulus, carbon fibre-reinforced high performance polymer.
According to Victrex, the brackets, now manufactured from its PEEK 90HMF40, have been developed by Airbus Helicopters and are in serial production for commercial use after receiving the relevant component qualification. The successful substitution of metal has resulted in a 40% reduction in weight and costs. The injection-moulded polymer solution replaces the higher cost manufacture of the bracket machined from an aluminum block.
Victrex explains that the fibre-reinforced polymer (FRP) structure of the A350 XWB's aircraft door uses an outer skin coupled with a bracing structure on the inside. A fitting, now manufactured from Victrex PEEK 90HMF40 thermoplastic, connects the outer skin to points on the internal bracing structure. The two components form a box-type support structure to exploit the maximum geometrical moment of inertia.
Christian Wolf, Head of Aeroplane Doors Research and Technology at Airbus Helicopters, explains the operation and significance of the PEEK component, "In terms of the standard load case, i.e. the internal cabin pressure, this point-type joint reduces the deformation on the outer skin, thereby maintaining the aerodynamic quality of the aircraft door. All components in the aircraft door are of a singly-redundant design. If a component near the bracket fails, the bracket will provide an alternative path for transferring structural loads and is therefore part of the aircraft's primary structure."
Victrex says that, by using its carbon fibre reinforced PEEK 90HMF40 polymer instead of the aluminium previously used, Airbus Helicopters has successfully manufactured an equivalent component that provides a range of benefits. It claims that weight and production costs have each been reduced by 40%. In addition, joining the PEEK component, instead of an aluminum component, to a thermoset makes drilling much easier. Optimised carbon fibre reinforced plastic (CFRP) drills improves the quality of the holes compared with the previous solution.
Specified by Airbus, Victrex claims its PEEK 90HMF40 easily withstands the moisture that continuously accumulates inside aircraft doors, whereas aluminium, which is prone to corrosion, needed a special surface coating to prevent corrosion. "The suitable material, supplied by Victrex, as well as their expertise and collaboration with their materials experts have contributed to the successful development and component qualification. The expertise gained from the initial use of fibre reinforced PEEK can be transferred to other components and to other areas of application with similar requirements," says Wolf.
Victrex explains, in the aerospace business, the "design and build" process, e.g. development in accordance with a given specification, is a possible option for producing structural components. In this process, the developer has additional freedom in matters such as the selection of materials. "90HMF40 is a special high performance thermoplastic which is also suitable for load bearing structural components as now used for the first time in the Airbus A350-900 and therefore in regular airline operations. This first application is certain to be quickly followed by others," explains Uwe Marburger, Aerospace Business Development Manager at Victrex.
Photo provided by Victrex
Wabash and Carver will highlight their composite moulding presses at the SAMPE 2018 Conference & Exhibition on 23-24 May in Long Beach, California, US.
Following its strategy to address composites end-use industries specifically, JEC Group is organising The Future of Composites in Transportation, a two-day event taking place on 27-28 June in Chicago.
EconCore will unveil the latest developments in its thermoplastic honeycomb core production technology at NPE2018 on 7-11 May in Orlando, Florida, US.