24 March 2015
24 March 2015
Compotool has released a new tooling board product that it says represents a radical new approach to composite tooling.
"By focusing specifically on tooling technology we have dedicated all our resources to solving some of the perennial issues with composite tooling. We are pleased to have come to a refined product range that simply does its job extremely well. Rather than representing an incremental improvement on products already available on the market, what we have created can be considered a significant break-through," says Managing Director, Paul Hackett.
According to Compotool, the system includes the tooling board, adhesive and surface sealer and is therefore perfect as a high accuracy pattern system or for rapid prototyping and short run direct tooling. CT850 is a high performance tooling board with a coefficient of thermal expansion equal to carbon and has temperature capability of up to 850°C. It has very low thermal conductivity so all the heat applied from the autoclave goes into the laminated part rather than the tooling board, giving an improved surface finish, significantly reducing autoclave time and also allowing faster ramp rates. Its machinability is also a clear advantage, with wear on cutting tools being equal to that of machining wood or MDF.
"The tooling board is a natural product, totally inert, no VOC's," confirms Hackett, "but it’s what it can do for your production processes that gets most of our clients excited." The board is a poor conductor of heat unlike epoxy tooling blocks and therefore can be cycled through the thermal curing process very quickly. It retains its dimensions even through rapid cure and cooling, so it gives great reductions in autoclave time saving money and allowing for more rapid development of parts. With its extreme temperature capability of 850°C, Compotool explains that either medium or high temperature pre-pregs can be used, enabling a full cure at high temperature to be achieved in the tool in one process, thus avoiding the need for a subsequent post cure.
"You can start to think of your tool development phase in terms of hours rather than in days and weeks" explains Hackett, "that's radical!"
Compotool claim that an additional benefit is that the CT850 can be used as a drilling or machining jig after cure as the mould or part will still fit perfectly. It explains that potential users of the board will also be pleased with the environmental credentials of this product. It is totally natural, which means that when the tool is no longer needed it can be ground up and put back into the earth.