NetComposites
Attwater

L&L Launch Seal Room Temperature Curing Elastic Sealants and Adhesives

13 January 2015

L&L Launch Seal Room Temperature Curing Elastic Sealants and Adhesives

 

 

 

L&L launch SEAL A-J Series of elastic sealants and adhesives, a range of high performance, room temperature curing paste materials formulated to meet the demanding requirements of the global Commercial Vehicles industry.

According to L&L, typical applications for this new range of materials include:

  • Elastic bonding and sealing of bus / coach roof, side panel, luggage door and floor panels,
  • Elastic bonding and sealing of truck high roof panels, body structures, cockpit and pedal plate areas,
  • Backfilling and sealing exposed joints,
  • Elastic bonding and sealing construction / agricultural vehicle roof, cabin side wall and door panels.

L&L’s A-J series materials are a range of elastic sealants designed to completely seal joints in the body structure to prevent water, noise, air, dust and fumes from intruding into the interior compartment of a commercial vehicle. The range also includes elastic adhesive bonding materials with an excellent balance of strength, elongation and creep resistance for applications requiring robust assembly of dissimilar substrates. A-J series materials completely cure at room temperature via a one-component technology system.

L&L explains that the key features of its SEAL A-J range include:

  • Robust adhesion without primers to most metals and composites for optimum acoustic and anti-corrosion sealing,
  • Enhanced worker safety, with formulations available that are free of solvents, VOC’s and isocyanates,
  • No shrinkage for reduced rework on bonded structures,
  • Full cure at room temperature via atmospheric moisture curing technology,
  • Wide range of cure speeds,
  • Broad range of mechanical properties from elastic sealants to creep resistant elastic adhesives.

Photo provided by L&L Products.







Related / You might like...

Cobra International Launches Composite Windsurfer LT

Cobra International has started mass production of the new Windsurfer LT board.

CCM Hockey Sticks Incorporate TFP Nonwovens

Technical Fibre Products (TFP) reports that its lightweight nonwovens play a key part in enhancing the composite fabrication of the next generation of CCM Hockey sticks.

Eventsport Presents Bandy Sticks Reinforced by TeXtreme

INXIDE has collaborated with Eventsport and Swedish elite players to develop the next generation of bandy sticks, the RELEASE, reinforced with TeXtreme.