06 January 2015
06 January 2015
Tepex performance composites from Lanxess subsidiary Bond-Laminates has been used to improve the mechanical strength of fibre-reinforced thermoplastic compression moulded cover on the rear muffler of the BMW i8.
According to Lanxess, it is fabricated in a direct long fibre thermoplastic (DLFT) process from a polypropylene compression moulding compound reinforced with long glass fibre rovings. An insert made of Tepex dynalite 104-RG601 is used as the surface layer. “With its stiffness at high temperatures, it ensures that the cover undergoes no deformation or failure in the hot environment of the rear muffler. What is more, our composite improves the strength and impact resistance of the component in freezing temperatures,” explains Harri Dittmar, Composites Expert at Bond-Laminates.
Lanxess explains the Tepex insert is 0.5 mm thick and made of a polypropylene matrix, incorporating 47 percent by volume continuous glass fibre rovings as a single-layer fabric. “Thanks to this insert, the stiffness of the cover increases by a factor of four at room temperature and a factor of six at the operating temperature of the rear muffler,” explains Dittmar. Lanxess claims that impact resistance benefits as well. In penetration tests to DIN EN ISO 6603-2, the Tepex dynalite formulation used proved to be eight to nine times more impact resistant at room temperature than a DLFT compression moulding compound based on polypropylene. “At temperatures of -30 °C, the impact resistance is even 10 times higher – DLFT based on polypropylene will splinter under these conditions in a crash, our Tepex will not,” Dittmar said.
Tepex is also described as an option for locally reinforcing components made of other thermoplastic compression moulding compounds and forming materials. For example, the mechanical properties of Tepex-reinforced DLFT polypropylene materials are on par with glass-mat-reinforced and glass-fabric-reinforced thermoplastic systems (GMT and GMTex) based on polypropylene. “In this case, the combination of Tepex with the DLFT process opens up considerable savings potential, for instance in the fabrication of underbody components,” Dittmar explains. Polypropylene-based, low-weight reinforced thermoplastics (LWRT), which are used to manufacture underbody panels due to their high sound absorption, can also be significantly stiffened with Tepex surface layers. Using a single-layer Tepex component preserves the acoustic effect. “The result is components that can easily withstand the mechanical loads associated with road traffic.”
Photo provided by Lanxess.
Wabash and Carver will highlight their composite moulding presses at the SAMPE 2018 Conference & Exhibition on 23-24 May in Long Beach, California, US.
Velox is intensifying its activities in Eastern Europe and Russia and will exhibit at Plastpol on 22-25 May 2018 in Kielce, Poland, alongside long-term partner Lubrizol.
Following its strategy to address composites end-use industries specifically, JEC Group is organising The Future of Composites in Transportation, a two-day event taking place on 27-28 June in Chicago.