NetComposites
Thermwood

Wilson-Burt Bridge Gets New FiberSPAN Cantilever Sidewalk

22 December 2015

Wilson-Burt Bridge Gets New FiberSPAN Cantilever Sidewalk

Wilson-Burt Bridge has a new 5 1/2 ft. wide, 442 ft long FiberSPAN cantilever sidewalk as part of a full bridge rehabilitation project valued at $4.2 million.

According to Composite Advantage, a “Sidewalk Closed” sign used to hang on the Niagara County, New York Wilson-Burt Bridge. The girder structure carries motor traffic and pedestrians across Eighteen Mile Creek. With Fiber Reinforced Polymer (FRP) panels weighing less than 8 pounds per square foot, the Composite Advantage product continues to gain momentum over more conventional concrete options due to its light weight and corrosion resistance.

“This project is another example of how the cantilever sidewalk system can meet the growing demand for pedestrian and cycling activities,” says Scott Reeve, President of Composite Advantage. “On Wilson-Burt Bridge, the sidewalk was old, crumbling from wear and tear and it was too narrow to support modern traffic requirements. Our light weight FiberSPAN product made it possible for designers to increase clear sidewalk width to 5 1/2 ft and maintain a dead load less than the original weight.”

Composite Advantage says, for Wilson-Burt Bridge, the FiberSPAN cantilever sidewalk was designed to support a live load of 85 psf, while minimising deflections to less than ¼ inch (L/500) and handle a temperature differential of 100 degrees Fahrenheit. Twenty prefabricated sidewalk sections were delivered to the job site ready for installation on floor beams extending perpendicular from the existing bridge structure. The sidewalk panels were manufactured with a 1.76 percent cross-slope top surface for water drainage. The cross-slope is an easier and more cost-effective approach than sloping support beams or installing shims. The 22 ft long panels have a shop applied non-slip surface. Internal steel connection points were used to attach the railing directly to the sidewalk panels.

 


Photo provided by Composite Advantage





Related / You might like...

Lightweight Technologies Forum in Parallel with Composites Europe 2018

The Lightweight Technologies Forum will take place in parallel to Composites Europe, on 6-8 November 2018 in Stuttgart, Germany.

Tecniplas Presents FRP Tanks at Food Fair

Tecniplas will exhibit FRP tanks suitable for contact with drinking water at the Fispal Tecnologia food and drink trade fair in São Paulo, Brazil, on 26-28 June.

ACMA Announces Winners of Architecture Design Challenge

The American Composites Manufacturers Association (ACMA) has unveiled the winners of this year’s Composites Design Challenge, a design competition that encourages college architecture students to find innovative ways to integrate composite constructions into architectural production.