AOC and ECS Environmental Solutions Manufacture Wastewater Tunnel

07 May 2013

AOC and ECS Environmental Solutions worked together to create an integral part of the city of Austin’s complex wastewater infrastructure project.

The companies say the new 3.9 mile wastewater tunnel increases capacity for the downtown district and facilitates residential and business growth in the area. An important part of the project is an odour control system.

ECS claim it provided the odour control equipment and relied on AOC’s Vipel resin for more than 1,000 feet of fibreglass ductwork and additional accessories. The ductwork ranges in size from 12 inches to 72 inches in diameter. Approximately half of the ductwork is buried below ground and had to be able to withstand thousands of pounds of high-density traffic driving over the site. Additional elements of the project include field joint kits, flexible connectors, control and back-draft dampers, bolt gaskets and two fibreglass exhaust fans rated at 40,000 cubic feet per minute (CFM).

ECS say it manufactured all of the fibreglass ductwork using a state-of-the-art computerised filament winder. The fibre was impregnated with AOC’s Vipel K022 corrosion-resistant vinyl ester resin, which is ideally suited for filament winding. “The K022 resin was the best choice for this project,” says Jeff Jones, President of ECS. “Some of the gases in the air stream are corrosive – hydrogen sulphide and ammonia. There’s also sulphuric acid. Pipes built with this resin are very resistant to what goes in them: They will not easily corrode.”

The company say that to help ease installation, it prefabricated and sub-assembled the duct system at its facility, then shipped it to Austin about an hour away. A field crew of five from ECS travelled to the construction site and handled all the field layup.

“We work in a controlled environment in the shop, but in the field you are open to the elements,” says Jones. “Some of the days we were in Austin were cold and others were really hot. We had to adjust promotion levels and add inhibitors to work with the resin long enough to do a quality job under tough conditions.” AOC’s Scott Lane, Product Leader, offered technical assistance that helped ECS re-formulate the resin. Eric Stuck, AOC sales representative, also assisted ECS in meeting the demands of this material-intensive project. “With the long runs and thick pipes, we went through material much faster than normal, and AOC was very good at meeting this fluctuation in demand,” says Jones. “If we ran out of resin on this job, it would have put the project to a halt. AOC got materials here when we needed them. They were fantastic to work with!”

Photo provided by Kelley and Associates Advertising.

Share this story

Related / You might like...

COBRA International and Flite: Range of New Electric Foiling Composite Surfboards That Reach 45kmh

COBRA International is collaborating with Flite, the Australian-based electric foiling surfboard manufacturer, on Fliteboard and Fliteboard PRO – two state of the art, electric foiling composite surfboards that reach speeds of up to 45kmh.

Business Growth Accelerates Across Motorsport Valley

Get your tickets now for the MIA’s 5th Annual Business Growth Conference on 11 July 2019 – the must-attend event for businesses from the world-leading motorsport and high-performance engineering industry of Motorsport Valley.

MotoE Ready to Race: All of the Ego Corsa Machines Built by the End of May Thanks to CRP Meccanica and CRP Technology

Preparations are in progress for the resumption of the activities of the FIM Enel MotoE World Cup after the setback last March, when a fire in Jerez destroyed much of the material for the MotoE, Ego Corsa machines included.