NetComposites
Advanced Engineering 2018

The Composite Trailer: A Green Revolution in Transport

07 November 2010

An aerodynamic shaped composite truck trailer has been developed that weighs 1200 kg less than one made from steel.

EPL Composite Solutions developed a new material for the trailer within the EU funded research project CleanMould.

The new composite material contains double the volume of glass fibres compared to common composites, using a low viscosity thermoplastic resin from Cyclics Corporation in Germany. Glass fibre mats impregnated with resin powder are placed into vacuum bag on a mould and heated to 200C where the powdered resin melts.

Five percent of fuel can be saved through the weight reduction, but even more important is its improved shape. This allows the designers to change its aerodynamic properties and the design has an inherent drag reduction of 13 percent that can be further improved to 20 percent with optimisation of the design. At high speeds, such as motorway cruising, this aerodynamic drag is the dominant factor in determining heavy goods vehicle fuel consumption. With the new shape another 10 percent of fuel can be saved.

The prototypes have been tested thoroughly on a series of demanding test tracks at the Motor Research Industry Association (MIRA) in Warwickshire, the biggest test ground in the UK. They included a braking test, speed bumps and cobblestone roads.

Deflections and accelerations through the trailer have been measured to see which parts in the trailer are under high stress or strain. The results so far are very promising and the engineers envisage already the next steps: The composites are ready to roll out into the industry now, says Matthew Turner, CleanMould project coordinator and Composite Engineer at EPL.





Share this story


Related / You might like...

Coriolis Composites Secures Contract with National Institute for Aviation Research

Coriolis Composites has been selected by the National Institute for Aviation Research (NIAR) at Wichita State University (WSU), US, to provide a thermoplastics capable Automated Fibre Placement (AFP) system.

Boeing and Thermwood Demonstrate New 3D Printing Technology

Boeing and Thermwood have employed additive manufacturing technology to produce a large, single-piece tool for the 777X programme. The project is demonstrating that additive manufacturing is ready to produce production quality tooling for the aerospace industry.

CRP USA Presents Windform Composite Materials at Satellite Innovation 2018

CRP USA will display solutions for the space industry manufactured in the Windform family of materials at Satellite Innovation 2018 at the Silicon Valley Computer History Museum, Mountain View, California, US, on 9-11 October.