NetComposites
Advanced Engineering 2018

Delcam and KUKA to Show Robot Machining at JEC

09 April 2010

CADCAM developer Delcam will link with industrial-robot manufacturer KUKA to demonstrate machining by robot at the JEC exhibition to be held in Paris next week.

The companies believe that robots could provide a lower-cost alternative to machine tools for the manufacture of larger composite components, both in the machining of master models and tooling, and in the trimming and drilling of the moulded parts.

Until now, machining by robot has been limited to a small number of specialist production operations. However, Delcam say that developments undertaken recently in their PowerMILL machining software have made it far easier to program robots for a much wider range of applications. The ability to program the robot offline from 3D CAD data is both faster and more efficient than the “teach and learn” approach that is often used to create instructions for the equipment.

According to Delcam, this easier operation could enable composite manufacturers to take advantage of the many potential benefits of using robots. Firstly, the cost of installing a robot is far less than the price of a large machine tool with a similar working envelope. In addition, the flexibility of the robot means that complex operations can be carried out in a single set-up, so cutting production times and reducing the number of fixtures needed.

Robots do have their disadvantages since they struggle to machine harder materials and cannot match the tolerances possible with modern machine tools. However, they can be used successfully in any area where softer materials need to be machined to accuracies of tenths of a millimetre. This can be more than adequate for components that might be several metres in length, as is often the case for composite tooling and parts for marine, aerospace, autosport and rail applications.






Related / You might like...

Alvant Supports £28m Safran-Led Aircraft Landing Gear Project

Alvant has been appointed to work on a two-year, £28 million project titled Large Landing Gear of the Future, which aims to deliver a 30% weight reduction and assist the aerospace industry’s drive to reduce fuel consumption and carbon emissions.

3D Printed Drone Prototype Wins Red Dot 2018 Design Award

Hexadrone’s 3D printed Tundra prototype, manufactured by CRP Technology via laser sintering (LS) technology using Windform SP and Windform XT 2.0 carbon composite materials, has won the Red Dot Award 2018 in the drone category.

Norco Composites Invests in New Equipment

UK company Norco Composites has invested in a larger spray booth and a new cutting and kitting machine to enable the company to increase productivity in line with growing demand from its marine customers.