NetComposites
Advanced Engineering 2018

20% Reduction in Cycle Time Offer by New Aluminium Moulding Tools

03 September 2006

Project Alamo, a 2-year European Union funded research programme coordinated by Rapra Technology, is drawing to a close with some potentially useful results.

The project was initiated to investigate innovative uses of anodised aluminium in the field of thermoplastic moulding, concentrating on injection and rotational moulding, with the ultimate aim of competing directly with steel tooling.

Aluminium has several known advantages for tooling applications – easy machining, good thermal properties, light weight and excellent recyclability but it has suffered from a lack of wear and chemical resistance. The anodised coating perfected by the team from across Europe has given the wear and chemical resistance without compromising the inherent beneficial properties of aluminium.

The programme members combined expertise in various fields - anodising, materials testing, mould manufacture, moulding and 3D moulding simulation, using both injection moulding and rotational moulding techniques to produce test tools which compared traditional P20 steel, aluminium, and anodised aluminium mould tools (for rotational moulding and injection moulding).

The results were promising. The rotational moulding tool exhibited a 20% reduction in cycle time compared to a conventional aluminium tool due to the rapid heating and cooling made possible by the high emissivity of anodising combined with the excellent thermal conductivity of aluminium.

There was a corresponding reduction in energy usage and the resultant mouldings were thoroughly tested and showed no difference in material properties.

The injection mould was a four impression tool which compared wear rates over 10,000 mouldings of an abrasive glass filled nylon compound. The anodised aluminium insert performed close to the standard of the steel one whereas the non-anodised aluminium insert showed marked wear in the gate area, visible to the naked eye.

The final phase of the Alamo project has been to make some industrial demonstrators in order to expand on the positive results of the tests phase. These results are expected around November 2006 when the project reaches the end of its current funding. However the resulting technology will continue under the guidance of the SME partners in the project.





Share this story


Related / You might like...

Cobra International Exhibits Product Range at CAMX 2018

Cobra International will showcase a range of composite products at CAMX 2018, including carbon fibre components for the automotive, transportation, marine, water sports and luxury sectors.

Prodrive Develops Process for Recyclable Thermoplastic Composites

UK company Prodrive Composites has developed a process for manufacturing recyclable composite components that can satisfy future end-of-life requirements without any compromise in the performance of the original parts. The company says the P2T (Primary to Tertiary) process not only simplifies recycling, but endows a composite material with the potential to fulfil three or more useful lifetimes.

Elemental RP1 Sports Car Showcases Capabilities of Tailored Fibre Placement

Designers at Elemental Motor have utilised tailored fibre placement (TPF) to extend the use of carbon composites in its RP1 sports car.