NetComposites
Airtech

New Porsche Racing Prototype Begins Testing

24 June 2005

The development of a new prototype by Porsche made from Kevlar/carbon fibre composites for customer racing in the LMP2 (Le Mans Prototype 2) category of the 2006 American Le Mans Series has commenced.

This marks the beginning of the testing period for the new racing sportscar, which is made from a carbon-fibre Kevlar body.

The prototype is powered by a newly-developed 90-degree V8 endurance engine, fitted with ACO regulation air restrictors, delivering around 480 hp from a 3.4-litre capacity. The lightweight power plant features a very low centre of gravity, four valves per cylinder, a dry-sump lubrication system and single cylinder throttle valves.

The six-speed sequential constant-mesh gearbox with a triple-disc carbon fibre racing clutch is a structural part of the chassis and is operated by a steering wheel-mounted paddle shift system. Like the Porsche Carrera GT, the new prototype’s monocoque chassis is constructed of carbon fibre. Attached to this extremely strong yet lightweight framework is a front and rear double-wishbone suspension, with adjustable springs, anti-roll bars and four-way shock absorbers. Porsche

Providing optimum braking power, the brake system includes twin master cylinders, adjustable brake balance and internally vented carbon brake discs measuring 380mm at the front and 355mm at the rear. As an integral partner in the car’s development process, Michelin supplies the race tyres for the new Porsche prototype.

In compliance with the 2006 ALMS regulations, the new Porsche LMP2 weighs in at only 750kg. This minimal weight was achieved through an intelligent, highly integrated lightweight vehicle concept. As the prototype is eventually intended for customer racing, the development engineers had the task of reaching the minimal weight without the extensive use of exotic, and hence expensive, lightweight materials.





Share this story


Related / You might like...

Case Study: ENATA’s High Performance Foiler

The ENATA FOILER is a radical evolution in motor yacht design with its unique hydro-foiling system effortlessly flying the yacht 1.5 m above the waves.

CRP Discusses 3D Printing in Boat Building

CRP Technology will present its Selective Laser Sintering (SLS) technology and patented Windform composite materials at the MetsTrade 2018 marine equipment, materials and systems trade show on 13-15 November in Amsterdam, the Netherlands.