Producer of Novel RTM components needed

06 June 2000

3 Tex, Inc is looking for an manufacturer with specific experience and specialty in producing RTM composite/fiber reinforced small parts. The parts are to be produced using S-glass woven fiberglass fabric in an acrylic modified ployester MEKP actuated resin using two part hard tooling and low pressure injection with gel-coat surfacing. The project involves two simultaneous lines of development and production, a major recreational consumer use and a non-recreational public agency use. Initial production will be approximately 100 assemblies as a proof of production process demonstration. The latter use is ultimately projected as 100,000 units for a major existing manufacturing client and may require the use of kevlar/epoxy versus S-glass. Production volume in stages for the former use is estimated at a similar number. Contact Richard March

Share this story